|
|
Build Your Online Product Catalogs?
| Product Name: |
GLPOLY XK-F20ST1 is a high performance, electrical insulation
|
| Supply Ability: |
100000 |
| Related proudcts |
bergquist, |
| Specifications |
320*320*0.25 |
| Price Term: |
FOB |
| Port of loading: |
1 |
| Minimum Order |
1 |
| Unit Price: |
1 |
|
It sounds easy and simple to make thermally conductive insulator, but there are just two or three high quality thermal insulator manufacturers, GLPOLY is included.
For many thermal management engineer, Bergquist thermally conductive insulator is preferred, or take it as benchmark even they don¡¯t use it finally. The main raw materials are fiberglass(or PI), silicone oil and thermally conductive powder. it is very simple, isn¡¯t it? but few of manfacturers can make quality thermal insulator with high performance and reliability. There are always some problems, either the low thermal performance or dielectric strength.
We are undervaluing peers, I have experienced that some peers bought thermally conductive insulator from us. GLPOLY is one of the leading expert in the development and production of thermal insulator, taking Bergquist etc as benchmark.
A motorized chair mannufacturer consulted us about thermally conductive insulator. They wanted to use a local alternative product to replace Bergquist Sil-Pad A1500, requesting an equivalent of performance or better. The customer had tested many similar samples before and failed each of them, because the temperature rise of chip is 95 degree, exceeding design requirement. Customer is misguided in expecting an higher thermal conductivity.
We recommended a thermal insulator XK-F20ST1 with 2.3W/mK, but customer doubted whether the thermal conductivit is high enough, ¡°the thermal conductivity of samples we had tested before were 2.0W/mK, is 2.3W/mK enough?¡°. Actually, in order to enhance dielectric strength, some suppliers use materials which is ***remtal to heat transfer and customer doesn¡¯t know ***ail. We suggest customer test it first, ¡°the cost high performance thermal matieral is proportional to thermal conductivity, we must consider the necessary of using a higher performance thermal material. If it is unworkable, we¡¯ll provide another high performance product¡±. Customer accepted our suggestion and tested the 2.3W/mK thermally conductive insulator. Final |
| Company: |
SHENZHEN GOLDLINK TONGDA ELECTRONICS CO.,LTD.
|
| Contact: |
Ms. huayan Luo |
| Address: |
Room 616,619, huafeng xin 'an commercial building, zone 45, bao 'an district, shenzhen |
| Postcode: |
518101 |
| Tel: |
0755-27579310 |
| Fax: |
0755-27579350 |
| E-mail: |
|
|
|
|
Home
